Thomas, J; Kumar, G A; Unnikrishnan, N V; Nampoori, V P N; Vallabhan, C P G(Elsevier, 2000)
[+]
[-]
Abstract:
Optical absorption and emission spectral studies of various phthalocyanine (Pc) molecules in PVA matrix have been reported for the first time. The recorded spectra are analyzed to get the important spectral parameters, such as optical absorption cross-section (σa), emission cross-section (σe), oscillator strength (f), fluorescence bandwidth (Δλ), emission wavelength (λ), radiative decay time (τ) and optical gain (G). Analysis shows that the emission cross-section and optical gain are maximum in the NdHPc2-doped PVA matrix. However, a comparison of the calculated emission parameters with that of borate glass matrix show that they are many times smaller in the present matrix.
Ravi Kumar, A V; Padmaja, G; Nampoori, V P N; Vallabhan, C P G(Springer, November , 1989)
[+]
[-]
Abstract:
Absorption spectra of formaldehyde molecule in the gas phase have been recorded using photoacoustic (PA) technique with pulsed dye laser at various power levels. The spectral profiles at higher power levels are found to be different from that obtained at lower laser powers. Two photon absorption (TPA) is found to be responsible for the photoacoustic signal at higher laser power while the absorption at lower laser power level is attributed to one photon absorption (OPA) process. Probable assignments for the different transitions are given in this paper.
Sajan, D George; Vallabhan, C P G; Heck, M; Radhakrishnan, P; Nampoori, V P N(Taylor & Francis, 2002)
[+]
[-]
Abstract:
An open cell photoacoustic (PA) configuration has been employed to evaluate the thermal diffusivity of intrinsic InP as well as InP doped with tin and iron. Thermal diffusivity data have been evaluated from variation of phase of PA signal as a function of modulation frequency. In doped samples, we observe a reduced value for thermal diffusivity in comparison with intrinsic InP. We also observed that, while the phase of the PA signal varies linearly with the square root of chopping frequency for doped samples, the intrinsic material does not exhibit such behaviour in the experimental frequency range. These results have been interpreted in terms of the heat generation and phonon assisted heat diffusion mechanisms in semiconductors.
Sajan, D George; Aneeshkumar, B; Radhakrishnan, P; Nampoori, V P N; Vallabhan, C P G(Society of Photo-Optical Instrumentation Engineers, 2004)
[+]
[-]
Abstract:
An open-cell configuration of the photoacoustic (PA) technique is employed to determine the thermal and transport properties of intrinsic Si and Si doped with B (p-type) and P (n-type). The experimentally obtained phase of the PA signal under heat transmission configuration is fitted to that of theoretical model by taking thermal and transport properties, namely, thermal diffusivity, diffusion coefficient, and surface recombination velocity, as adjustable parameters. It is seen from the analysis that doping and also the nature of dopant have a strong influence on the thermal and transport properties of semiconductors. The results are interpreted in terms of the carrier-assisted and phonon-assisted heat transfer mechanisms in semiconductors as well as the various scattering processes occurring in the propagation of heat carriers.
Girijavallabhan, C P; Radhakrishnan, P; Nampoori, V P N; George, N A; Paul, T; Sebastian,M T(Journal of Materials Science Letters,Kluwer Academic Publishers, 2000)
Sathy, P; Reji, Philip; Nampoori, V P N; Vallabhan, C P G(IOP, 1994)
[+]
[-]
Abstract:
S1 to S3 excited singlet state absorption and two-photon absorption in Rhodamine 6G at the pump wavelengths of 532 and 1064 nm respectively are investigated. The advantages of employing the pulsed photoacoustic technique for conveniently observing excited singlet state absorption are discussed. It is shown that, since photoacoustics and fluorescence are complementary phenomena, analysis using both techniques will yield a better understanding of optical processes in molecules like Rhodamine 6G.
Riju, C Issac; Harilal, S S; Geetha K, Varier; Bindhu, C V; Nampoori, V P N; Vallabhan, C P G(Society of Photo-Optical Instrumentation Engineers, February , 1997)
[+]
[-]
Abstract:
Pulsed photoacoustic studies in solutions of C70 in toluene are made using the 532-nm radiation from a frequency-doubled Nd:YAG laser. It is found that contrary to expectation, there is no photoacoustic (PA) signal enhancement in the power-limiting range of laser fluences. Instead, the PA signal tends to saturate during optical power-limiting phenomenon. This could be due to the enhanced optical absorption from the photoexcited state and hence the depletion of the ground-state population. PA measurements also ruled out the possibility of multiphoton absorption in the C70 solution. We demonstrate that the nonlinear absorption leading to optical limiting is mainly due to reverse saturable absorption.
Annieta, Philip; Radhakrishnan, P; Nampoori, V P N; Vallabhan, C P G(IOP, 1993)
[+]
[-]
Abstract:
Non-destructive testing d multilayer dielectric coatings (SiO2/TiO2
structure) has been carried out using the photoacoustic technique. This
technique makes use d a 10 mW He-Ne laser, a photoacoustic cell and a lock-in
amplifier. The chopped He-Ne laser beam is allowed to fall on the sample
placed in a photoacoustic cell. The acoustic signals thus generated are detected
using a microphone and the resulting output is processed by a lock-in amplifier.
The amplitude and phase of the signals were measured as a function of the
chopping frequency. Striking step-like variations are observed in me phase
against frequency plot which dearly reveals the different layers present in the
multilayer structure.
Nibu, A George; Vallabhan, C P G; Nampoori, V P N; Radhakrishnan, P(Society of Photo-Optical Instrumentation Engineers, January , 2002)
[+]
[-]
Abstract:
We discuss an open photoacoustic cell study on sulfer-doped
n-type InP wafer. The thermal diffusivity of the sample is evaluated from
the phase data associated with the photoacoustic signal as a function of
the modulation frequency under heat transmission configuration. Analysis
is made on the basis of the Rosencwaig-Gersho theory and the results
are compared with those from earlier reported photoacoustic studies
of semiconductors. Our investigation clearly indicates that the
instantaneous thermalization process is the major heat diffusion mechanism
responsible for the photoacoustic signal generation in an InP
sample.
Girijavallabhan, C P; Radhakrishnan, P; V P N Nampoori; Sajan, D George; George, A K(Smart Materials and Structures, July 5, 2007)
[+]
[-]
Abstract:
Complete thermal characterization of liquid crystal mixtures in the smectic
phase consisting of various relative volume fractions of cholesterol and
1-hexadecanol have been carried out using the photoacoustic technique.
Thermal diffusivity values of these liquid crystal mixtures are evaluated using
the open cell photoacoustic technique whereas the thermal effusivity value is
measured using the conventional photoacoustic technique. From the
measured values of these transient thermophysical parameters, the thermal
conductivity and heat capacity of the sample under investigation are
calculated. Analyses of the results show that all the thermophysical
parameters depend strongly on the volume fraction of the constituents.
Results are interpreted in terms of enhanced hydrogen bonding and the
consequent enhancement in cohesive thermal energy transport with
increasing volume fraction of 1-hexadecanol
Sajan, D George; Dilna, S; Prasanth, R; Radhakrishnan, P; Vallabhan, C P G; Nampoori, V P N(Society of Photo-Optical Instrumentation Engineers., 2003)
[+]
[-]
Abstract:
We report a photoacoustic (PA) study of the thermal and transport properties of a GaAs epitaxial layer doped with Si at varying doping concentration, grown on GaAs substrate by molecular beam epitaxy. The data are analyzed on the basis of Rosencwaig and Gersho’s theory of the PA effect. The amplitude of the PA signal gives information about various heat generation mechanisms in semiconductors. The experimental data obtained from the measurement of the PA signal as a function of modulation frequency in a heat transmission configuration were fitted with the phase of PA signal obtained from the theoretical model evaluated by considering four parameters—viz., thermal diffusivity, diffusion coefficient, nonradiative recombination time, and surface recombination velocity—as adjustable parameters. It is seen from the analysis that the photoacoustic technique is sensitive to the changes in the surface states depend on the doping concentration. The study demonstrates the effectiveness of the photoacoustic technique as a noninvasive and nondestructive method to measure and evaluate the thermal and transport properties of epitaxial layers.
Girijavallabhan, C P; Radhakrishnan, P; Nibu, A George; Aneeshkumar, B(Journal of Physics D : Applied Physics, April 7, 1999)
[+]
[-]
Abstract:
The photobleaching of the lasing dye Rhodamine 6G embedded in the solid
matrix poly(methyl methacrylate) was investigated using a photoacoustic technique.
Chopped laser radiation from an argon ion laser at four different wavelengths was used for
the study. Experimental results indicate that the photobleaching rate is directly proportional
to the incident laser power while it decreases with increase in concentration of the dye
molecules. In the present case we have not observed any dependence of photobleaching on
the chopping frequency. One-photon absorption is found to be responsible for the
photobleaching of the dye within the selected range of laser power
Sajan, D George; Aji, A Anapara; Warrier, P R S; Warrier, K G K; Radhakrishnan, P; Nampoori, V P N; Vallabhan, C P G(Elsevier, September , 2008)
[+]
[-]
Abstract:
Laser-induced nondestructive photoacoustic (PA) technique has been employed to determine the thermal diffusivity of nanometal (Ag) dispersed ceramic alumina matrix sintered at different temperatures. The thermal diffusivity values are evaluated by knowing the transition frequency from the amplitude spectrum of PA signal using the one-dimensional heat flow model of Rosencwaig and Gersho. Analysis of the data shows that heat transport and hence the thermal diffusivity value is greatly affected by the influence of incorporation of foreign atom. It is also seen that sintering temperature affects the thermal diffusivity value in a substantial manner. The results are interpreted in terms of variation in porosity and carrier-assisted heat transport mechanism in nanometal dispersed ceramics.
Sajan, D George; Rajesh, K; Warrier, K G K; Radhakrishnan, P; Nampoori, V P N; Vallabhan, C P G(October 29, 2011)
[+]
[-]
Abstract:
The laser induced non-destructive photoacoustic technique has been employed
to measure the thermal diffusivity of lanthanum phosphate ceramics prepared
by the sol–gel route. The thermal diffusivity value was evaluated by knowing
the transition frequency between the thermally thin to thermally thick region
from the log–log plot of photoacoustic amplitude versus chopping frequency.
Analysis of the data was carried out on the basis of the one-dimensional
model of Rosencwaig and Gersho. The present investigation reveals that the
sintering temperature has great influence on the propagation of heat carriers
and hence on the thermal diffusivity value. The results were interpreted
in terms of variations in porosity with sintering temperature as well as with
changes in grain size.
Sasi Kumar, P R; Nampoori, V P N; Vallabhan, C P G(Elsevier, August 1, 1995)
[+]
[-]
Abstract:
The photoemission optogalvanic (POG) effect has been investigated in a neon-neodymium hollow cathode discharge using
cw laser excitation. Both positive and negative effects were observed. It was found that the amplitude of the POG signal was
unstable near the instability region of the discharge.
Sasi Kumar, P R; Nampoori, V P N; Vallabhan, C P G(IOP, 1993)
[+]
[-]
Abstract:
A two-photon induced photoemission optogalvanic effect which brings about a change in the discharge voltage when a pulsed dye laser beam is focused on a tungsten electrode has been described. The experiment is performed with N2, NO2 and Ar discharges. The magnitude of the signal voltage is studied as a function of laser energy and discharge current. The effective quantum efficiency in the discharge is found to be larger than that in the vacuum condition.
Sasi Kumar, P R; Nampoori, V P N; Vallabhan, C P G(IOP, 1993)
[+]
[-]
Abstract:
A two-photon induced photoemission optogalvanic effect which brings about a change in the discharge voltage when a pulsed dye laser beam is focused on a tungsten electrode has been described. The experiment is performed with N2, NO2 and Ar discharges. The magnitude of the signal voltage is studied as a function of laser energy and discharge current. The effective quantum efficiency in the discharge is found to be larger than that in the vacuum condition.
Ajith Prasad, K C; Nampoori, V P N; Vallabhan, C P G(Elsevier, 1996)
[+]
[-]
Abstract:
Photoemission optogalvanaic (POG) effect has been observed by irradiating copper target electrode, in a nitrogen discharge cell using 1.06 μm and frequency doubled 532 nm Nd:YAG laser pulse. Measurement of the nature of the variation of POG signal strength with 532 nm laser fluence confirms the two photon induced photoelectric emission from copper. However, using 1.06 μm laser pulses thermally assisted photoemission is observed.
Girijavallabhan, C P; Radhakrishnan, P; Nampoori, V P N; Sajan, D George(Physical Review, American Physical Society, October 16, 2003)
[+]
[-]
Abstract:
In this paper, we report the in-plane and cross-plane measurements of the thermal diffusivity of double
epitaxial layers of n-type GaAs doped with various concentrations of Si and a p-type Be-doped GaAs layer
grown on a GaAs substrate by the molecular beam epitaxial method, using the laser-induced nondestructive
photothermal deflection technique. The thermal diffusivity value is evaluated from the slope of the graph of the
phase of the photothermal deflection signal as a function of pump-probe offset. Analysis of the data shows that
the cross-plane thermal diffusivity is less than that of the in-plane thermal diffusivity. It is also seen that the
doping concentration has a great influence on the thermal diffusivity value. Measurement of p-type Be-doped
samples shows that the nature of the dopant also influences the effective thermal diffusivity value. The results
are interpreted in terms of a phonon-assisted heat transfer mechanism and the various scattering process
involved in the propagation of phonons.
Nibu, A George; Vallabhan, C P G; Nampoori, V P N; Radhakrishnan, P(Optical Society of America, August , 2002)
[+]
[-]
Abstract:
Photothermal beam deflection studies were carried out with GaAs epitaxial double layers grown on semi-insulating GaAs substrates. The impurity densities in thin epitaxial layers were found to influence the effective thermal diffusivity of the entire structure.