Radhakrishnan, P; Nampoori, V P N; Girijavallabhan, C P; Thomas Lee, S; Suresh, Kumar P; Unnikrishnan, K P; Sugunan, S(INSTITUTE OF PHYSICS PUBLISHING, April 24, 2003)
[+]
[-]
Abstract:
In this communication, we discuss the details of fabricating an off-line fibre
optic sensor (FOS) based on evanescent wave absorption for detecting trace
amounts of Fe3+ in water. Two types of FOS are developed; one type uses
the unclad portion of a multimode silica fibre as the sensing region whereas
the other employs the microbent portion of a multimode plastic fibre as the
sensing region. Sensing is performed by measuring the absorption of the
evanescent wave in a reagent medium surrounding the sensing region. To
evaluate the relative merits of the two types of FOS in Fe3+ sensing, a
comparative study of the sensors is made, which reveals the superiority of
the latter in many respects, such as smaller sensing length, use of a double
detection scheme (for detecting both core and cladding modes) and higher
sensitivity of cladding mode detection at an intermediate range of
concentration along with the added advantage that plastic fibres are
inexpensive. A detection limit of 1 ppb is observed in both types of fibre and
the range of detection can be as large as 1 ppb–50 ppm. All the
measurements are carried out using a LabVIEW set-up.
Radhakrishnan, P; Nampoori, V P N; Girijavallabhan, C P; Shelly John, M(Measurement Science and Technology, UK, November 12, 1998)
[+]
[-]
Abstract:
A novel sensing technique for the in situ monitoring of the rate of pulsed laser
deposition (PLD) of metal thin films has been developed. This optical fibre based sensor
works on the principle of the evanescent wave penetration of waveguide modes into the
uncladded portion of a multimode fibre. The utility of this optical fibre sensor is
demonstrated in the case of PLD of silver thin films obtained by a Q-switched Nd:YAG laser
which is used to irradiate a silver target at the required conditions for the preparation of thin
films. This paper describes the performance and characteristics of the sensor and shows how
the device can be used as an effective tool for the monitoring of the deposition rate of silver
thin films. The fibre optic sensor is very simple, inexpensive and highly sensitive compared
with existing techniques for thin film deposition rate measurements
Radhakrishnan, P; V P N Nampoori; Girijavallabhan, C P; Thomas Lee, S; Jose, Gin; Unnikrishnan, N V(Journal of Optics A: Pure and Applied Optics, July 12, 2001)
[+]
[-]
Abstract:
The fabrication and characterization of a fibre optic pH sensor based on
evanescent wave absorption is presented. The unclad portion of a
multi-mode optical fibre is coated with a pH sensitive dye, which is
immobilized by the sol–gel route. The sensitivity of the device has been
found to increase when multiple sol–gel coatings are used as the sensing
region. The dynamic range and the temporal response of the sensor are
investigated for two different dyes, namely bromocresol purple and
bromocresol green. The performance of the device is evaluated in terms of
the results obtained during actual measurements