Rani, Joseph(Hutig & Wepf Verlag,Basel, October 5, 1987)
[+]
[-]
Abstract:
Compounding of styrene-butadiene copolymer/polybutadiene , natural rubber/
ethylene-propylene-diene terpolymer and natural rubber/butadiene-acrylonitrile copolymer
blends was done in three different ways and their curing behaviour and the
tensile properties of the es are compared.
The mechanism of devulcanization of sulfur-vulcanized natural rubber with aromatic disulfides and aliphatic
amines has been studied using 23-dimethyl-2-butene (C5H1,) as a low-molecular weight model compound. First C6H12
was vulcanized with a mixture of sulfur, zinc stearate and N-cyclohexyl-2-benzothiazylsulfenamide (CBS) as accelerator
at 140 °C, resulting in a mixture of addition products (C(,H 1 i-S,-C5H 1 i ). The compounds were isolated and identified
by High Performance Liquid Chromatography (HPLC) with respect to their various sulfur ranks. In it second stage, the
vulcanized products were devulcanized using the agents mentioned above at 200 °C. The kinetics and chemistry of the
breakdown of the sulfur-hridges were monitored. Both devulcanization agents decompose sulfidic vulcanization products
with sulfur ranks equal or higher than 3 quite effectively and with comparable speed. Di phenyldisulfide as devulcanization
agent gives rise to a high amount of mono- and disulfidic compounds formed during the devulcanization,
hexadecylamine, as devulcanization agent, prevents these lower sulfur ranks from being formed.
ABSTRACT: Phenol was chemically attached to low molecular weight
chlorinated polyisobutylene and stearic acid respectively. These phenolic
antioxidants were characterised by IR, 1H NMR and TGA. The efficiency and
permanence of these bound antioxidants were compared with conventional
antioxidants in natural rubber vulcanisates. The vulcanisates showed comparable
ageing resistance in comparison to vulcanisates containing conventional
antioxidants. The presence of liquid polymer bound phenol reduce the amount of
plasticiser required for compounding.
ABSTRACT: The rheological and extrudate behaviour of natural rubber/latex
reclaim blends were evaluated using a capillary viscometer . The study shows
that the viscosity of natural rubber decreases marginally on the addition of
latex reclaim while the variation of viscosity with shear rate is not affected.
The temperature sensitivity of the blends is not affected significantly with the
addition of latex reclaim . The extrudates of natural rubber/latex reclaim
blends are smooth up to the addition of about 50 wt. percent latex reclaim in
filled natural rubber compounds.
Rani, Joseph(John Wiley & Sons. Inc, August 20, 1998)
[+]
[-]
Abstract:
ABSTRACT: Rubber seed oil was used as a multipurpose ingredient in natural rubber
(NR) and styrene butadiene rubber (SBR) compounds. The study shows that the oil,
when substituted for conventional plasticiser, imparts excellent mechanical properties
to NR and SBR vulcanizates. Further, it also improves aging resistance, reduces cure
time, increases abrasion resistance and flex resistance, and reduces blooming.
Filled compounds of natural rubber, isobutylene-isoprene rubber
and styrene-butadiene rubber compounds were extruded through a laboratory
extruder by varying the feeding rate at different temperatures and revolutions
per minute. The extruded compounds were vulcanized up to their optimum cure
times and the mechanical properties of the vulcanizates were determined. The
properties suggest that there is a particular feeding rate in the starved fed region
which results in maximum mechanical properties. The study shows that running
the extruder at a slightly starved condition is an attractive means of improving
the physical properties.
Rani, Joseph(Hitthig & Wepf Verlag, Basel, October 13, 1986)
[+]
[-]
Abstract:
A carbon black filled 50/50 natural rubber (NR)/styrene-butadiene rubber (SBR)
blend is vulcanized using several conventional curing systems designed by varying the
amounts of sulphur and accelerator. The cure characteristics and the properties of the
vulcanizates are compared. The quantity and quality of crosslinks in each case are
evaluated by chemical probes to correlate them with the properties.
Rani, Joseph(Huthig & Wepf Verlag, Basel, June 5, 1991)
[+]
[-]
Abstract:
Antioxidants were attached to hydroxy-terminated liquid natural rubber by modified
Friedel-Crafts alkylation reaction using anhydrous zinc chloride as catalyst. The rubber
bound antioxidants were found to be less volatile and less extractable compared to
conventional antioxidants. The bound antioxidants were tried both in latex compounds
and dry rubber compounds. The vulcanizates showed improved ageing resistance
compared to vulcanizates based on conventional antioxidants.
In natural rubber/high styrene resin microcellular sheets, part of
natural rubber was replaced by latex reclaim prepared from waste
latex products. The mechanical properties and cell structure of
the products were evaluated. It was found that latex reclaim can
replace about 30% of natural rubber without affecting the technical
properties of the microcellular sheets.
Zinc butyl xanthate [Zn(bxt)2] was prepared
in the laboratory . The effect of this xanthate with zinc
diethyl dithiocarbamate (ZDC) on the vulcanization of natural
rubber ( NR), polybutadiene rubber (BR), and NR/BR
blend has been studied at different temperatures. The
amounts of Zn (bxt)2 and ZDC in the compounds were optimized
by varying the amount of ZDC from 0 . 75 to 1.5 phr
and Zn (bxt)2 from 0 . 75 to 1 .5 phr. The cure characteristics
were also studied . HAF filled NR, BR, and NR / BR blend
compounds were cured at different temperatures from 60 to
150 C. The sheets were molded and properties such as tensile strength, tear strength, crosslink density and elongation
at break, compression set, abrasion resistance, etc. were
evaluated. The results show that the mechanical properties
of 80NR/20BR blends are closer to that of NR vulcanizates,
properties of 60NR/40BR blends are closer to BR vulcanizates,
while the 70NR/30BR blends show an intermediate
property.
Sunil,K Narayanankutty(Rapra Technology, August 29, 2006)
[+]
[-]
Abstract:
Mechanical properties and thermal degradation of natural rubber compounds
containing castor oil were studied to evaluate its suitability as plasticizer.
Naphthenic oil was used as a reference plasticizer. The cure time was marginally
lower in the case of castor oil mixes, probably due to the presence offree fatty acids
in it. The tear strength and modulus were better in the case of mixes containing
castor oil, while most of the other mechanical properties were comparable to
the mixes containing naphthenic oil. The heat build up and compression set were
higher than that of the naphthenic oil mixes. Thermal studies showed an increase
of 8 °C in the temperature of initiation of degradation and an increase of 6 °C in
the temperature at which the peak rate of degradation occurred. The peak rate
of degradation was comparable to that of the reference compound
Zinc salts of ethyl, isopropyl and butyl xanthates were prepared in the laboratory. The
effect of these xanthates with zinc diethyldithiocarbamate (ZDC) on the vulcanization
of HAF filled NR compound has been studied at different temperatures. The
rubber compounds with the three xanthate accelerators and ZDC were cured at various
temperatures from 60°C to 150°C. The sheets were moulded and properties such as tensile
strength , tear strength , cross-link density, elongation -at-break, compression set, heat
build up, abrasion resistance, flex resistance , etc. were evaluated . The properties
showed that zinc xanthate/ZDC accelerator combination has a positive synergistic effect
on the mechanical properties of NR compounds. The curing of HAF filled NR compound
containing zinc xanthate /ZDC is slightly slower than the curing of the corresponding gum
compounds . It is observed that, by gradually increasing the amount of the accelerator, the
cure time of black filled NR compound can be made equal to that of the gum compou
Rani, Joseph(OPA (Overseas Publishers Association), May 28, 1995)
[+]
[-]
Abstract:
Amine Terminated Liquid Natural Rubber (ATNR) was used as a plasticiser in filled NR and NBR
compounds replacing oil/DOP. The scorch time and cure time were found to be lowered when ATNR
was used as the plasticiser. ATNR was found to improve the mechanical properties like tensile strength,
tear strength and modulus of the vulcanizates . The ageing resistance of the vulcanizates containing ATNR
was superior compared to the vulcanizates containing oil/DOP.
Rani, Joseph(Gordon and Breach Science Publishers S.A., October 16, 1992)
[+]
[-]
Abstract:
Butyl (IIR) tube reclaim (RR) was mixed with carbon black filled natural rubber (NR) compounds at
various percentages. The blend containing a low percentage of RR was found to show improved ageing
resistance and improved processability with out much reduction in the mechanical properties.
Rani, Joseph(John Wiley & Sons, Inc., March 20, 2000)
[+]
[-]
Abstract:
ABSTRACT: Zinc salts of ethyl, isopropyl, and butyl xanthates were prepared in the
laboratory. They were purified by reprecipitation and were characterized by IR, NMR,
and thermogravimetric analysis techniques. The melting points were also determined.
The rubber compounds with different xanthate accelerators were cured at temperatures
from 30 to 150°C. The sheets were molded and properties such as tensile strength,
tear strength, crosslink density, elongation at break, and modulus at 300% elongation
were evaluated. The properties showed that all three xanthate accelerators are effective
for room temperature curing.