Mohanan, P; Girijavallabhan, C P; Aanandan,C K; K G Nair(Indian Journal of Radio & Space Physics, February , 1984)
[+]
[-]
Abstract:
A forward - biased point contact germanium signal diode placed inside a waveguide section along the E -vector is found to
introduce significant phase shift of microwave signals . The usefulness of the arrangement as a phase modulator for microwave
carriers is demonstrated. While there is a less significant amplitude modulation accompanying phase modulation , the insertion
losses are found to be negligible. The observations can be explained on the basis of the capacitance variation of the barrier layer
with forward current in the diode
Mridula, S; Sreedevi, Menon K; Lethakumary,B; Binu, Paul; Aanandan,C K; Mohanan, P(Microwave and Optical Technology Letters, July 20, 2002)
[+]
[-]
Abstract:
A broadband rectangular tnicrostrip antenna utilizing
an electromagnetically coupled L-strip feed is presented. Experimental
study shows a 2:1 VSWR bandwidth of a 10% and excellent
cross-polarization performance with a radiation coverage almost as
same as that of the rectangular microstrip antenna fed by conventional
methods. The variation of bandwidth for different feed parameters is also studied. The proposed antenna is suitable for broadband
communications
Haskins, P M; Dahele, J S(Department of Electronics, March 14, 1996)
[+]
[-]
Abstract:
Two three-clement polarisation-agile active microstrip patch
arrays have been developed . The radiating elements are square
patches each with two transistors mounted on adjacent edges. The
patches radiate orthogonal modes , the relative phase of which can
be varied. Radiation patterns show good agreement with
predictions from theory, in both linear and circular polarization,
and no grating lobes were observed
Sangster,A J(Microwave and Optical Technology Letters, September , 1991)
[+]
[-]
Abstract:
A new microstrip antenna element is described which exhibits polarization
agility. This is achieved by employing a T-slot radiator
which is driven by the edge fields of a balanced microstrip line. The
balanced line can support two propagating modes. namely. an even
mode and an odd mode, and be switching between these modes. the
orthogonal arms of the T-slot radiator are separately excited thus
forming orthogonally polarized radiated fields. A nucrostrip patch
antenna, which displays polarization agility using the sane mechanism,
is also described
Choudhury, P K(Microwave and Optical Technology Letters, November 25, 2002)
[+]
[-]
Abstract:
A fairly rigorous analytical treatment of the power characteristics
of dielectric optical waveguides with Piet Hein core-cross
sectional geometry is presented in this paper. This kind of wareguide
structure would be advantageous owing to the absence of corners,
which are found in rectangular guides, resulting in undesirable loss (hit
to the scattering of light. In order to simplify this theoretical approach.
em approximation of vanishing refractive index difference between the
guiding and the non-guiding sections is implemented. The variation eJ
logarithmic power is shown for different dimensions of the core, corresponding
to different azimuthal modal indices. It is found that the nutlet
with higher index values carry less logaritlunic power in the lower tail
of the propagation 's constant range, and this feature affects the higher
tail. A better kind of uniformity of the power distribution is observed
near the higher tail of the range of propagation Constants
Ceramics of composition BaO-Ln2O3-STiO2 have been prepared with four elements (Ln=La,Pr,Nd.Sm) by a conventional solid state ceramic preparation route and the dielectric properties measured in the microwave frequency range
The dielectric ceramics BaNd2Ti3Oto, BaNd2Ti4O12 and BaNd2Ti5O14 have been prepared by
Conventional solid state ceramic route. The sintered ceramic samples have been characterized by
X-ray diffraction and Scanning Electron Microscopy (SEM). The dielectric properties in the
microwave frequency range have been measured using conventional microwave dielectric
resonator methods. The BaNd2Ti1O10, BaN2Ti4O12 and BaNd2Ti5O14 have dielectric constants
(Er) ~ 60, 84 and 77 respectively. They have relatively high quality factors
Abdul Khalam,L; Sreemoolanadhan,H; Ratheesh, R; Mohanan, P; Sebastian,M T(ELSEVIER, 2003)
[+]
[-]
Abstract:
Microwave dielectric resonators (DRs) based on Ba(B1,2Nbi/2)03 [B' = La, Pr, Nd, Sm, Eu, Gd, Tb, Dy, Ho, Y, Yb, and In] complex
perovskites have been prepared by conventional solid state ceramic route. The dielectric properties (relative permittivity, Er; quality factor, Q;
and resonant frequency, rr) of the ceramics have been measured in the frequency range 4-6 GHz using resonance methods. The resonators
have relatively high dielectric constant in the range 36-45, high quality factor and small temperature variation of resonant frequency. The
dielectric properties are found to depend on the tolerance factor (t), ionic radius (r), and lattice parameter (ap)
Mailadil,Sebastian T; Sam,Solomon; Ravindran,Ratheesh(Regional Research Laboratory, April , 1999)
[+]
[-]
Abstract:
Microwave ceramic dielectric resonators (DRs) based on RETiNbO6
(RE = Ce, Pr, Nd, Sm, Eu, Gd, Tb, Dy, Y, and Yb)
have been prepared using the conventional solid -state ceramic
route. The DR samples are characterized using XRD and SEM
methods. The microwave dielectric properties are measured
using resonant methods and a net work analyzer . The ceramics
based on Ce, Pr, Nd, and Sin have dielectric constants in the
range 32-54 and positive coefficient of thermal variation of
resonant frequency (r,). The ceramics based on Gd, Tb, Dy, Y.
and Yb have dielectric constants in the range 19-22 and
negative Tf
The propagation of pulse waves in coplanar waveguides
(CPWs) is investigated, and these CPWs are assumed to be fabricated
on a single -layer low- temperature co-fired ceramic (LTCC) substrate.
The input pulse wave can be a Gaussian pulse or a sinusoldally modulated
Gaussian pulse. Based on the standard Galerkin 's method in the
spectral domain, combined with fast Fourier transform (FFT), the pulse
waveform and delay in CPWs are demonstrated and compared for a second plate, oriented orthogonally to the primary planar element,
thus producing a crossed planar monopole (CPM), which is
simpler to produce and has lower cost than a conical monopole. In
this paper, further measurements have been made on this element
Suma,M N; Sreedevi, Menon K; Bijumon, P V; Sebastian,M T; Mohanan, P(Microwave and Optical Technology Letters, April 20, 2005)
[+]
[-]
Abstract:
In this paper, we present an effective excitation of a reelangular
dielectric resonator antennas (DRA) with a conductor-hacked
coplanar waveguide (CB-CPW). The radiation and resonance characteristics
are found to van,, depending on the orientation of the DR on
doe coplanar feed line. The effect of finite and infinite ground planes of
CB-CPIV on the radiation characteristics of the rectangular DRA is
studied. The orientation and position of the DR are optimized for maximum
gain and bandwidth. The optimized antenna ,geometry offers
--10.46 dBi gain and 7.5% bandwidth with low cross-polar radiation
characteristics
Paulson,M; Sona,Kundukulam O; Aanandan,C K; Mohanan, P(Department of Electronics, September , 2001)
[+]
[-]
Abstract:
The arrow shaped microstrip antenna, which produces
dual frequency dual polarisation operation with considera-ble size reduction compared to conventional patches has been
reported [I]. These antennas provide greater area reduction and
improved gain compared to drum shaped patches [2]. Prediction
of the resonance frequency of drum shaped patches [3] and circular
patches for broadband operation [4] are available in the literature.
In this Letter, we propose empirical formulas for calculating
the resonance frequencies of the arrow shaped microstrip antenna.
These antennas can be employed for obtaining dual frequency
with the same polarisation, bandwidth enhancement, circular
polarisation etc. by varying its different parameters or by introducing
slots. The proposed design equations provide an easier and
simple way of predicting the resonant frequencies of these patches.
A simple technique for calculating the resonance frequencies of a
compact arrow-shaped microstrip antenna is presented and discussed . The accuracy of the method is validated by experimental results
Sona,Kundukulam O; Paulson,M; Aanandan,C K; Mohanan, P; K G Nair(Department of Electronics, October , 2002)
[+]
[-]
Abstract:
A dual-port microstrip antenna with a crescent shaped
patch with excellent isolation betwecn the ports has been reportcd [I].
Since circular-sided geometries are inore compact than rectangular
oncs, thcy find morc applications in microstrip arrays. The crcscent
shaped antenna geometry [ I ] provides greater area rcductioii compared
to other circular sided patches for broadband operation [2]. In this
Lctter, formulac for calculating thc TM, I and TMZI mode resonant
frequencies of this microstrip antenna, obtained by modifying the
equations of a standard circular patch [3] are presentcd. Thcorctical
results are compared with experimental observations aid the validity
of the computation is established.
Biju Kumar, S; Raveendranath, U; Mohanan, P; Mathew, K T; Hajian,M; Ligthart, L P(Microwave and Optical Technology Letters, July 20, 2000)
[+]
[-]
Abstract:
A simple and efficient method for determining the complex
permittivity of dielectric materials from both reflected and transmitted signals is presented. It is also novel because the technique is implemented using two pyramidal horns without any focusing mechanisms. The dielectric constant of a noninteractive and distributive (NID) mixture of dielectrics is also determined
Vermeeren,G; Rogier,H; Olyslager,F; Zutter De,D(IEE Electronics letters,UK, September 13, 2001)
[+]
[-]
Abstract:
A single-feed rectangular-ring microstrip antenna is proposed for
indoor communication under the Bluetooth protocol. The
dimensions of the antenna together with the location of the feed
point are optimized through field simulations in order to cover the
Bluetooth bandwidth and to avoid linear polarization. The
performance and the efficiency of the antenna are illustrated in a
real indoor environment
Hsieh,Gui-Bin; Chen,Ming-Huang; Wong,Kin-Lu Wong(IEE Electronics letters,UK, June 21, 2001)
[+]
[-]
Abstract:
A novel technique for obtaining dual-hand circular polarization
(CP) radiation of a single-feed circular microstrip antenna in
proposed and demonstrated. By embedding two pain of arc shaped
slots of proper lengths close to the boundary of a circular
patch, and protruding one of the arc-shaped slots with a narrow
slit, the circular microstrip antenna can perform dual-hand CP
radiation using a single probe feed. Details of the antenna design
Binoy,G S; Aanandan,C K; Mohanan, P; Vasudevan, K(Microwave Engineering Group,Department of Electronics, January 5, 2002)
[+]
[-]
Abstract:
A novel dual frequency design of a square microstrip antenna coaxially
fed along the diagonal with a chip capacitor mounted at the bottom of
the stub is introduced. This design provides enhanced area reduction and
good cross-polarization levels. The antenna design can be used as a compact
antenna system where limited size is a major requirement. The details of the
antenna design and experimental results are presented
Sona,Kundukulam O; Manju,Paulson; Aanandan,C K; Mohanan, P(Microwave and Optical Technology Letters, December 5, 2001)
[+]
[-]
Abstract:
Dual frequency operation is achieved from a compact
microstrip antenna by loading a pair of narrow slots close to its radiating
edges. The two frequencies have parallel polarization planes and similar
radiation characteristics. The ratio between the two operating frequencies
can be tuned in the range (1.14-1. 24), which is much smaller than that
of similar designs. The above excellent radiation characteristics are
achieved along with an area reduction of - 75% compared to the
standard rectangular patch
Jianlang,Li; Liren,Liu; Yingchun,Guo; Huaisheng,Wang; Changhe,Zhou(Microwave and Optical Technology Letters, December 20, 1999)
[+]
[-]
Abstract:
The transient interaction between a refraction index grating
and light beams during simultaneous writing and thermal fixing of
a photorefractive hologram is investigated. With a diffusion- and
photovoltaic-dominated carrier transport mechanism and carrier thermal
activation (temperature dependent) considered in Fe:LiNbO3 crystal, from
the standpoint of field-material coupling, the theoretical thermal fixing
time and the space-charge field buildup, spatial distribution, and temperature
dependence are given numerically by combining the band transport
model with mobile ions with the coupled-wave equation