Santhakumari, N C; Vallabhan, C P G(Elsevier, May , 1992)
[+]
[-]
Abstract:
D.C. and a.c. electrical conductivities, dielectric constant and dielectric loss factor in single crystals of ethylenediammonium sulphate, (H3NCH2CH2NH3)(SO4), have been measured axiswise as a function of temperature. Anomalous variations in all the above properties at 480 K indicate the occurrence of a phase transition in the above material at this temperature. The existence of such a phase transition is also confirmed by DSC measurements. Electrical conductivity results are analysed and the activation energies of conduction at different temperature regions have been evaluated from the logσ vs 103T−1 plot. Possible mechanisms for the electrical conduction process are discussed, the available results being in favour of a proton transport model.
Girijavallabhan, C P; V P N Nampoori; Harilal, S S; Riju, C Issac; Bindhu C V(Journal of Physics D : Applied Physics, January 24, 1997)
[+]
[-]
Abstract:
Optical emission studies of C2 molecules in plasma obtained by Nd:YAG
laser ablation of graphite in a helium atmosphere are reported for irradiances in the
range (1–9:2/ x 1010 W cm−2. The characteristics of the spectral emission intensity
from the C2 (Swan band) species have been investigated as functions of the
distance from the target, ambient pressure and laser irradiance. Estimates of
vibrational temperatures of C2 species under various irradiance conditions are
made. Results of measurements performed under different ambient helium gas
pressures are also discussed.
Jayaraj, M K; Vallabhan, C P G(IOP Publishing, 1990)
[+]
[-]
Abstract:
AC thin film electroluminescent devices of MIS and MISIM have been fabricated with a novel dielectric layer of Eu2O3 as an insulator. The threshold voltage for light emission is found to depend strongly on the frequency of excitation source in these devices. These devices are fabricated with an active layer of ZnS:Mn and a novel dielectric layer of Eu2O3 as an insulator. The observed frequency dependence of brightness-voltage characteristics has been explained on the basis of the loss characteristic of the insulator layer. Changes in the threshold voltage and brightness with variation in emitting or insulating film thickness have been investigated in metal-insulator-semiconductor (MIS) structures. It has been found that the decrease in brightness occurring with decreasing ZnS layer thickness can be compensated by an increase in brightness obtained by reducing the insulator thickness. The optimal condition for low threshold voltage and higher stability has been shown to occur when the active layer to insulator thickness ratio lies between one and two.
Thomas, Baby; Sathianandan, K; Nampoori, V P N; Vallabhan, C P G; Ramachandran, T(American Institute of Physics, September , 1991)
[+]
[-]
Abstract:
A high power Nz laser of the double-Blumlein type having a modified gas flow system,
electrode configuration, and discharge geometry with minimum inductance is described. By
incorporating a triggere’d-pressurized spark gap switch, arc-free operation was achieved
for a wide E/P range. The device gives a peak power in excess of 700 kW with a FWHM of
3 ns and an efficiency of 0.51%, which is remarkably high for a pulsed nitrogen laser
system. The dependence of output power on parameters such as operating pressure, voltage,
and repetition rate are discussed.
Girijavallabhan, C P; Radhakrishnan, P; Nibu, A George; Aneeshkumar, B(Journal of Physics D : Applied Physics, April 7, 1999)
[+]
[-]
Abstract:
The photobleaching of the lasing dye Rhodamine 6G embedded in the solid
matrix poly(methyl methacrylate) was investigated using a photoacoustic technique.
Chopped laser radiation from an argon ion laser at four different wavelengths was used for
the study. Experimental results indicate that the photobleaching rate is directly proportional
to the incident laser power while it decreases with increase in concentration of the dye
molecules. In the present case we have not observed any dependence of photobleaching on
the chopping frequency. One-photon absorption is found to be responsible for the
photobleaching of the dye within the selected range of laser power
Girijavallabhan, C P; Radhakrishnan, P; V P N Nampoori; Shelly John, M(Measurement Science and Technology, UK, November 12, 1998)
[+]
[-]
Abstract:
A novel sensing technique for the in situ monitoring of the rate of pulsed laser
deposition (PLD) of metal thin films has been developed. This optical fibre based sensor
works on the principle of the evanescent wave penetration of waveguide modes into the
uncladded portion of a multimode fibre. The utility of this optical fibre sensor is
demonstrated in the case of PLD of silver thin films obtained by a Q-switched Nd:YAG laser
which is used to irradiate a silver target at the required conditions for the preparation of thin
films. This paper describes the performance and characteristics of the sensor and shows how
the device can be used as an effective tool for the monitoring of the deposition rate of silver
thin films. The fibre optic sensor is very simple, inexpensive and highly sensitive compared
with existing techniques for thin film deposition rate measurements.
Thomas, Baby; Ramachandran, T; Radhakrishnan, P; Nampoori, V P N; Vallabhan, C P G(IOP Publishing, 1991)
[+]
[-]
Abstract:
A low inductance, triggered spark gap switch suitable for a high-current fast discharge system has been developed. The details of the design and fabrication of this pressurized spark gap, which uses only commonly available materials are described. A transverse discharge Blumlein-driven N2 laser incorporating this device gives a peak output power of 700 kW with a FWHM of 3 ns and an efficiency of 0.51%, which is remarkably high for a pulsed nitrogen laser system.
Rajasree, K; Radhakrishnan, P; Nampoori, V P N; Vallabhan, C P G(IOP, 1993)
[+]
[-]
Abstract:
A pulsed Nd-YAG laser beam is used to produce a transient refractive index gradient in air adjoining the plane surface of the sample material. This refractive index gradient is probed by a continuous He-Ne laser beam propagating parallel to the sample surface. The observed deflection signals produced by the probe beam exhibit drastic variations when the pump laser energy density crosses the damage threshold for the sample. The measurements are used to estimate the damage threshold for a few polymer samples. The present values are found to be in good agreement with those determined by other methods.
Reji, Philip; Sathy, P; Nampoori, V P N; Jacob, Philip; Vallabhan, C P G(IOP, 1992)
[+]
[-]
Abstract:
Two-photon absorption in methanol solutions of Rhodamine 6G is investigated by photoacoustics using the second harmonic of a pulsed Nd:YAG laser. Competition between one-photon and two-photon processes is observed, depending critically on the sample concentration and input light flux.
Sasi Kumar, P R; Nampoori, V P N; Vallabhan, C P G(IOP, 1993)
[+]
[-]
Abstract:
A two-photon induced photoemission optogalvanic effect which brings about a change in the discharge voltage when a pulsed dye laser beam is focused on a tungsten electrode has been described. The experiment is performed with N2, NO2 and Ar discharges. The magnitude of the signal voltage is studied as a function of laser energy and discharge current. The effective quantum efficiency in the discharge is found to be larger than that in the vacuum condition.