Radhakrishnan, P; Nampoori, V P N; Girijavallabhan, C P; Shelly John, M(Measurement Science and Technology, UK, November 12, 1998)
[+]
[-]
Abstract:
A novel sensing technique for the in situ monitoring of the rate of pulsed laser
deposition (PLD) of metal thin films has been developed. This optical fibre based sensor
works on the principle of the evanescent wave penetration of waveguide modes into the
uncladded portion of a multimode fibre. The utility of this optical fibre sensor is
demonstrated in the case of PLD of silver thin films obtained by a Q-switched Nd:YAG laser
which is used to irradiate a silver target at the required conditions for the preparation of thin
films. This paper describes the performance and characteristics of the sensor and shows how
the device can be used as an effective tool for the monitoring of the deposition rate of silver
thin films. The fibre optic sensor is very simple, inexpensive and highly sensitive compared
with existing techniques for thin film deposition rate measurements
Nampoori, V P N; Radhakrishnan, P; Girijavallabhan, C P; Shelly John, M(Measurement Science and Technology, UK, November 12, 1998)
[+]
[-]
Abstract:
A novel sensing technique for the in situ monitoring of the rate of pulsed laser
deposition (PLD) of metal thin films has been developed. This optical fibre based sensor
works on the principle of the evanescent wave penetration of waveguide modes into the
uncladded portion of a multimode fibre. The utility of this optical fibre sensor is
demonstrated in the case of PLD of silver thin films obtained by a Q-switched Nd:YAG laser
which is used to irradiate a silver target at the required conditions for the preparation of thin
films. This paper describes the performance and characteristics of the sensor and shows how
the device can be used as an effective tool for the monitoring of the deposition rate of silver
thin films. The fibre optic sensor is very simple, inexpensive and highly sensitive compared
with existing techniques for thin film deposition rate measurements.
Sivasankara Pillai,V N; Radhakrishnan, P; Nampoori, V P N; Girijavallabhan, C P; Suresh, Kumar P(Journal of Optics : A Pure and Applied Optics, March 8, 2002)
[+]
[-]
Abstract:
A fibre optic technique for detecting trace amounts of nitrite compounds in
water is described. The off-line fibre optic sensor outlined here is based on
evanescent field absorption in a test solution formed by the reaction of nitrite
compounds in water with suitable chemical reagents. A short unclad portion
of a plastic clad silica fibre acts as the sensing region. The experimental
results clearly establish the usefulness of the present technique for detecting
very low concentrations of the order of 1 ppb (parts per billion) of nitrite
compounds with a large dynamic range of 1–1000 ppb. Such a high
sensitivity enables the present device to be used for measuring the nitrite
content in drinking water.
Girijavallabhan, C P; Nampoori, V P N; Radhakrishnan, P; Sheeba, M; Rajesh, M(Measurement Science and Technology, Institute of Physics Publishing, October 4, 2005)
[+]
[-]
Abstract:
The design and development of a fibre optic evanescent wave refractometer
for the detection of trace amounts of paraffin oil and palm oil in coconut oil
is presented. This sensor is based on a side-polished plastic optical fibre. At
the sensing region, the cladding and a small portion of the core are removed
and the fibre nicely polished. The sensing region is fabricated in such a
manner that it sits perfectly within a bent mould. This bending of the
sensing region enhances its sensitivity. The oil mixture of different mix
ratios is introduced into the sensing region and we observed a sharp decrease
in the output intensity. The observed variation in the intensity is found to be
linear and the detection limit is 2% (by volume) paraffin oil/palm oil in
coconut oil. The resolution of this refractometric sensor is of the order of
10−3. Since coconut oil is consumed in large volumes as edible oil in south
India, this fibre optic sensor finds great relevance for the detection of
adulterants such as paraffin oil or palm oil which are readily miscible in
coconut oil. The advantage of this type of sensor is that it is inexpensive and
easy to set up. Another attraction of the side-polished fibre is that only a
very small amount of analyte is needed and its response time is only 7 s.