ABSTRACT: The rheological and extrudate behaviour of natural rubber/latex
reclaim blends were evaluated using a capillary viscometer . The study shows
that the viscosity of natural rubber decreases marginally on the addition of
latex reclaim while the variation of viscosity with shear rate is not affected.
The temperature sensitivity of the blends is not affected significantly with the
addition of latex reclaim . The extrudates of natural rubber/latex reclaim
blends are smooth up to the addition of about 50 wt. percent latex reclaim in
filled natural rubber compounds.
Sunil K Narayanankutty(Taylor & Francis Inc., August 23, 2004)
[+]
[-]
Abstract:
The rheological characteristics of short Nylon-6 fiber-reinforced Styrene
Butadiene rubber (SBR) in the presence of epoxy resin-based bonding agent were
studied with respect to the effect of shear rate, fiber concentration , and temperature
on shear viscosity and die swell using a capillary rheonzeter. All the composites
containing bonding agent showed a pseudoplastic nature, which decreased
with increasing temperature. Shear viscosity was increased in the presence of
fibers. The temperature sensitivity of the SBR matrices was reduced on introduction
of fibers. The temperature sensitivity of the melts was found to be lower at
higher shear rates. Die swell was reduced in the presence of fibers. Relative viscosity
of the composites increased with shear rate. In the presence of epoxy resin
bonding agent the temperature sensitivity of the mixes increased. Die swell was
larger in the presence of bonding agent.
Sankar, T V; Ramachandran, A(John Wiley & Sons, 2002)
[+]
[-]
Abstract:
The gel strength, compressibility and folding characteristic of suwari (set) and kamaboko (set and cooked) gels prepared from rohu (Labeo rohita), catla (Catla catla) and mrigal (Cirrhinus mrigala) surimi were examined to understand the occurrence of suwari and modori phenomena in surimi from major freshwater carps. Suwari setting of gels did not take place at lower temperatures. Suwari gels showed good gel strength at 50 °C for rohu and at 60 °C for catla and mrigal after 30 min setting time. Incubation for 60 min decreased the gel strength at 60 °C for rohu and catla. Setting at 25 °C followed by cooking at 90 °C increased the gel strength. Increased setting temperature, however, decreased the gel strength of cooked gels. Gel strength and compressibility data were supported by folding characteristics.
The rheological behavior of a short-polyester-fiber-filled polyurethane
elastomer composite containing different bonding agents
has been studied in the temperature range 120-160°C and in the
shear rate range 63-608 s-'. The composite with and without
bonding agents showed a pseudoplastic behavior which decreased
with the increase of temperature. Composites containing bonding
agents based on polypropyleneglycol and 4,4'-diphenylmethanediisocyanate
showed the lowest viscosity values at a particular
shear rate, whereas composites containing a glycerol- (GL) based
bonding agent showed the highest viscosity. The viscosity of the
composite decreased sharply after a particular temperature (140°C) and the fall was less drastic in the composite containing
a GL-based bonding agent.
Sunil K Narayanankutty(Taylor & Francis Inc., 2005)
[+]
[-]
Abstract:
The rheological characteristics of short Nylon-6 fiber reinforced styrene butadiene
rubber (SBR) were studied using a capillary rheometer. The study was done with
respect to the effect of shear rate, fiber concentration, and temperature on shear
viscosity and die swell. All the melts showed pseudoplastic nature, which
decreased with increasing temperature. Shear viscosity increased in the presence
of fibers. Introduction of fiber reduces the temperature sensitivity of the rubber
matrix. A reduction in die swell was found in presence of fibers.
Fully burnt rice hull (rice hull ash) was tried as a low cost filler in place of precipitated
silica in NBR/PVC based microcellular soles. The mechanical properties of the soles
containing silica and ash are found to be comparable. The expansion is marginally
higher in the presence of ash, which permits to reduce the amount of blowing agent. Cell
structure of microcellular sheets remains unchanged when silica is replaced by ash.
Beyer,G J; Hagebo,E; Novgorodov,A F; Ravn,H L(EUROPEAN ORGANIZATION FOR NUCLEAR RESEARCH, November 7, 2002)
[+]
[-]
Abstract:
On line isotope separation techniques (ISOL) for production of ion beams of short-lived radionuclides
require fast separation of nuclear reaction products from irradiated target materials followed by a transfer into
an ion source. As a first step in this transport chain the release of nuclear reaction products from refractory
metals has been studied systematically and will be reviewed. High-energy protons (500 - 1000 MeV) produce
a large number of radionuclides in irradiated materials via the nuclear reactions spallation, fission and
fragmentation. Foils and powders of Re, W, Ta, Hf, Mo, Nb, Zr, Y, Ti and C were irradiated with protons
(600 - 1000 MeV) at the Dubna synchrocyclotron, the CERN synchrocyclotron and at the CERN PS-booster
to produce different nuclear reaction products.
The main topic of the paper is the determination of diffusion coefficients of the nuclear reaction products
in the target matrix, data evaluation and a systematic interpretation of the data. The influence of the ionic
radius of the diffusing species and the lattice type of the host material used as matrix or target on the
diffusion will be evaluated from these systematics. Special attention was directed to the release of group I, II
and III-elements. Arrhenius plots lead to activation energies of the diffusion process.
Nampoori, V P N; Kamalasanan, M N; Patel, M M(IOP, 1975)
[+]
[-]
Abstract:
Indium monofluoride was excited in a high-frequency discharge and the C-X system was photographed at a reciprocal dispersion of 0.3 AA mm-1 using a plane-grating spectrograph. Rotational analyses of the 0,0 1,0 2,2 3,3 4,4 2,4 3,5 4,6 and 5,7 bands have been carried out and the following molecular constants have been evaluated. Be'=0.2670(+or-3) cm-1, Be"=0.2628(+or-4) cm-1, alpha e'=0.0050(+or-4) cm-1, alpha e"=0.0020(+or-1) cm-1, De'=3.65(+or-5)*10-7 cm-1, De"=2.5(+or-3)*10-7 cm-1, beta e'=0.5(+or-2)*10-7 cm-1, beta e"=0.2(+or-1)*10-7 cm-1, re'=1.9672(+or-3) AA, re"=1.9853(+or-2) AA. The re" value agrees with the microwave absorption value 1.9854 AA.
Rani, Joseph(John Wiley & Sons. Inc, August 20, 1998)
[+]
[-]
Abstract:
ABSTRACT: Rubber seed oil was used as a multipurpose ingredient in natural rubber
(NR) and styrene butadiene rubber (SBR) compounds. The study shows that the oil,
when substituted for conventional plasticiser, imparts excellent mechanical properties
to NR and SBR vulcanizates. Further, it also improves aging resistance, reduces cure
time, increases abrasion resistance and flex resistance, and reduces blooming.
Rani, Joseph(John Wiley & Sons, Inc., October 22, 1997)
[+]
[-]
Abstract:
Rubber solutions were prepared and used for bonding wood pieces. The
effect of the variation of chlorinated natural rubber (CNR) and phenolformaldehyde
(PF) resin in the adhesive solutions on lap shear strength was determined. Natural
rubber and neoprene-based adhesive solutions were compared for their lap shear
strength. The storage stability of the adhesive prepared was determined. The change
in lap shear strength before and after being placed in cold water, hot water, acid,
and alkali was tested. The bonding character of these adhesives was compared with
different commercially available solution adhesives. The room-temperature aging
resistance of wood joints was also determined. In all the studies, the adhesive prepared
in the laboratory was found to be superior compared to the commercial adhesives.
Mohammed Yusuff, K K; Pearly Sebastian, Chittilappilly; Sridevi, N(Elsevier,Journal of Molecular Catalysis A: Chemical 286 (2008) 92–97, February 5, 2008)
[+]
[-]
Abstract:
Zeolite Y-encapsulated ruthenium(III) complexes of Schiff bases derived from 3-hydroxyquinoxaline-2-carboxaldehyde and 1,2-
phenylenediamine, 2-aminophenol, or 2-aminobenzimidazole (RuYqpd, RuYqap and RuYqab, respectively) and the Schiff bases derived from
salicylaldehyde and 1,2-phenylenediamine, 2-aminophenol, or 2-aminobenzimidazole (RuYsalpd, RuYsalap and RuYsalab, respectively) have
been prepared and characterized. These complexes, except RuYqpd, catalyze catechol oxidation by H2O2 selectively to 1,2,4-trihydroxybenzene.
RuYqpd is inactive. A comparative study of the initial rates and percentage conversion of the reaction was done in all cases. Turn over frequency
of the catalysts was also calculated. The catalytic activity of the complexes is in the order RuYqap > RuYqab for quinoxaline-based complexes and
RuYsalap > RuYsalpd > RuYsalab for salicylidene-based complexes. The reaction is believed to proceed through the formation of a Ru(V) species.
Neema,C P; Babu,C A(Department of Atmospheric Science, 2004)
[+]
[-]
Abstract:
This study deals with the salient features of the north Indian ocean associated with the summer monsoon. The focus is given on the Arabian sea mini warm pool, which is a part of the Indian ocean. It primarily study the certain aspects of the atmosphere and ocean variability in the north Indian ocean. The attempt were made to understand various aspects of time –scale variability of major features occurring in the Indian summer monsoon. The result from the thesis can be utilized as an input for model studies for prediction of monsoon, understanding ocean dynamics, radar tracking and ranging etc.
Neema,C P; Babu,C A(COCHIN UNIVERSITY OF SCIENCE AND TECHNOLOGY, 2004)
[+]
[-]
Abstract:
This study deals with the salient features of the north Indian ocean associated with the summer monsoon. The focus is given on the Arabian sea mini warm pool, which is a part of the Indian ocean. It primarily study the certain aspects of the atmosphere and ocean variability in the north Indian ocean. The attempt were made to understand various aspects of time –scale variability of major features occurring in the Indian summer monsoon. The result from the thesis can be utilized as an input for model studies for prediction of monsoon, understanding ocean dynamics, radar tracking and ranging etc.
Alex Paikada,Mathew; Sivasankara Pillai,V N(School of rural development and appropriate technology: CUSAT Environmental studies, 2005)
[+]
[-]
Abstract:
The study conducted on the salinity intrusion and seasonal water quality variations in the tidal canals of cochin. The main objectives are, salinity intrusion profile, water quality variation of the surface water of the canals,hierarchical utility of the water bodies and to understand the non-conservative components in the water body. The parameters monitored werepH,temperature,alkalinity,conductivity,DO(dissolvedoxygen),COD(chemical oxygen demand),BOD(biochemical oxygen demand0,chloride, total hardness, calcium hardness, dissolved phosphate, nitrate, total iron, sulphate, turbidity, total coliform and SUVA at 254nm. The tidal canals of GCDA were found to be creeks extending to the interior, canals inter connecting parts of the estuary or canals with seasonally broken segments. Based on utility the canals could be classified as: canals heavely polluted and very saline,canals polluted by urban waste , canals having fresh water for most part of the year and not much polluted, fresh water bodies heavily polluted.
During the rainy months carbon fixation by plankton is nonexistent,and during the dry months Chitrapuzha becomes a sink of phosphate. The study indicated abiotic subrouts for dissolved phosphate and revealed the potential pitfalls in LOICZ modeling exercise on sewage ladentidal canals. It was also found that all canals except for the canals of West cochin and chittoorpuzha have fresh water for some part of the year. The water quality index in the durable fresh water stretches was found to be of below average category.